su clubroadster si trova questo
http://www.clubroadster.net/vb_forum/sho...hp?t=25080
come cavolo è possibile far stare dentro al passaruota un 8j et0 senza allargare niente? che camber esagerato va messo??
http://www.clubroadster.net/vb_forum/sho...hp?t=25080
Citazione:How to fit 15x8+0 wheels
by scooby steve33
So the amount of people i see asking the same question over and over and over and over made me think it would benefit everyone if we just made a 15x8 0 offset thread. I had some on an NA so ill put in my two cent if other people have info on NBs and so on go for it.
WHEELS:
15x8 0et
TIRES:
you can run a
165 45 -15 really really low profile and stretch, looks like shit
195 45-15 some stretch, looks decent can go low with some camber
195 50 -15 a more substantial looking tires (taller sidewall) may be a tad bit harder to fit
205 and larger going to be tough to fit but can be done
Camber:
First off you dot have to "buy" camber. Your stock arm do all the adjusting one should need for these. Use the eccentrics on the control arms to increase or decrease camber. Then GET AN ALIGMENT! not one to match OEM specs but to make sure its not completely destroyed. Match the camber from side to side. check your toe, personally i try to run very very little toe.
Fenders
A roll is just fine it will work ive done it on 195 45s just fine. A slight pull will make everything easier but is not necessary. Ill sat it again YOU DO NOT NEED TO PULL YOU FENDERS with the correct amount of camber, tires and ride height it works fine
come cavolo è possibile far stare dentro al passaruota un 8j et0 senza allargare niente? che camber esagerato va messo??