A me la sonda da un diverso codice, anche con Torque, P0031 se non ricordo male
Per il tuo errore ho trovato questo, forse la sonda non è pienamente compatibile:
Oxygen sensor - no inversion detected
DTC P1170 - upper position / front bank [or front position]
[KL]
Detection Conditions
If the input voltage from the oxygen sensor remains below or above 0.45V for longer than 43 seconds, the ECM determines that there is no oxygen sensor inversion under the following monitoring conditions:
engine speed is above 1500 rpm
engine coolant temperature is above 80 degrees C
Diagnostic Support Notes
Per il tuo errore ho trovato questo, forse la sonda non è pienamente compatibile:
Oxygen sensor - no inversion detected
DTC P1170 - upper position / front bank [or front position]
[KL]
Detection Conditions
If the input voltage from the oxygen sensor remains below or above 0.45V for longer than 43 seconds, the ECM determines that there is no oxygen sensor inversion under the following monitoring conditions:
engine speed is above 1500 rpm
engine coolant temperature is above 80 degrees C
Diagnostic Support Notes