Wideband, cos'e', come funziona, a cosa serve

[lo/rez]

La LC-1 ha 3 uscite programmabili. Solitamente, si usa in questa maniera:
1) uscita programmata per far lavorare la WB come una NB => collegata al cablaggio originale
2) uscita programmata come WB => collegata allo strumentino
3) uscita programmata come WB => collegata alla EMB per fare datalogging (poi ti spiego meglio al tel)

Alberto,
punto 1 e 2 non ci piove.
Punto 3: Intanto mi informo, ma su quale contatto della EMB va collegata la WB secondo te?

Qui danno qualche dritta...:
There is different ways to do it. It's hard to find info out there as it seems most people have moved on to the Emanage Ultimate.

- If you don't need the Greddy boost connection, it can be used as A/F input. Update your software to v1.49 and A/F can be selected for that port.

- For those that are boosted, use the Throttle Position input (gray wire). But the input is displayed in percentage using the Greddy Support Tool.

- Alternatively you can try to find "emanage.tools.alpha" Freeware that you run instead of Support Tool for logging. It adds gauges for display and you can log A/F through either input wire 1) the boost connector 2)throttle position 3)AFM #1 4)AFM #2 and they are all configurable for range and voltage output.